Compared with Legacy, UEFI has better programmability, greater scalability, higher performance and higher security. If not, swap the order of boot devices so that your hard drive is first. If the boot entry is still not available, you can manually enter it in BIOS. The firmware maintains a list of installed storage devices that may be bootable floppy disk drives, hard disk drives, optical disk drives, tape drives, etc.
Save the changes and reboot your computer from the Windows DVD. After a few moments, you should see the install setup screen. A computer with UEFI architecture cannot boot from that media in native mode. Therefore, this tools is not suitable for creating an installation flash drive with Windows 7. While holding the Shift key, press Restart. This will bring up a blue window with several troubleshooting options. Find the Secure Boot setting, and if possible, set it to Disabled.
This option is usually in either the Security tab, the Boot tab, or the Authentication tab. I do not have a CD or floppy disk drive for the tablet. Dont forget to modify Autoexec. Once that is complete recreate the Primary Partition, exit out and restart the PC. Follow the prompts. Hello, Presently, I do not have a CD or floppy drive for this tablet.
I only have a USB flash drive, which I'm attempting to use to install Windows 98 operating system on the tablet. The tablet does not have an operating system at this time. Save these changes on exit and allow the system to restart. I'm not sure that this is even possible as 98 relies on the Install Media to be active through the Install Process and 98 didn't have any USB Support till the SE Version and even then it wasn't very good so I don't know if this will even work here.
After they it may fail to read the USB Stick. I hope that helps. When you have prepared the USB flash drive try to boot from it. If it works but you can't install Win98 from where it is then you will have to make the Hard Drive in the Tablet Bootable by typing sys. We will cross this bridge if needed later. Hello Thanks for the support. I downloaded the bootdisk and updated fdisk to a floppy drive on a different PC.
I tried a number of different modifications to Autoexec. There was further output to the screen which ended with the last line: Loading boot sector At this point there is a flashing cursor but will not take any input from keyboard. Nothing happens after this except occasionally the screen will show flashing text or color lines then return to the text ending in Can you recommend a next step to try?
0コメント